Electrical and Lighting Maintenance
Electrical and Lighting Maintenance
United Scientific™ Wire Stripper
This Wire Stripper quickly removes insulation without damaging wire.
Eisco™ Carbon Resistors
Quality carbon resistors for electrical experiments and general wiring in the laboratory.
Eisco™ Fuses
5mm x 20mm quick blow fuses feature clear transparent glass to see if fuse wire is broken
Eisco™ 10 Light Emitting Diodes (LEDs)
LEDs with diffused lenses. Maximum voltage 3.0 V D.C. Ideal for use on PCB or panel mount calibrations on a circuit board. LEDs provide a colored light source while using very little energy.
Eisco™ Stackable Battery Holder
Extend capacity or voltage.
Eisco™ Super Wire Stripper and Cutter
This heavy duty wire stripper and cutter has a dial adjuster for preset wire sizing and insulation removal. It strips and cuts heavy electrical and cable wires.
Eisco™ Capacitance Sub Box
Useful for general purpose electronic work.
GSC Go Science Crazy Battery Holder Size D
Battery Holder D Battery
Vernier™ Analog Protoboard Adapter
This connector makes it easy to wire the signal from a Vernier analog sensor into a non-Vernier interface.
Vernier™ Breadboard Cable (Analog)
The Breadboard Cable (Analog) provides an easy way for students to build their own sensor circuitry and input the signal into a Vernier interface for data acquisition.
Vernier™ SparkFun RedBoard with cable
The SparkFun RedBoard is an Arduino™-compatible board, which is perfect for use with the Vernier Arduino Interface Shield. A USB Mini-B cable is included.
Vernier™ Go to Easy Adapter
This adapter allows a Go!Temp or Go!Link* to connect to the USB port of a TI-Nspire handheld or TI-84 graphing calculator. The adapter has a USB standard-A receptacle which connects to the Go!Temp or Go!Link and a USB Mini-A USB plug that connects to the calculator. The adapter can also be used with the USB cable that comes with a Go!Motion.
Vernier™ Breadboard Cable (Digital)
The Breadboard Cable (Digital) provides an easy way for students to build their own sensor circuitry and input the signal into a Vernier interface for data acquisition.
Vernier™ Short Calculator Link Cable
This 6″ cable is used to connect a LabPro or CBL 2 to the I/O port of TI-73, TI-83, TI-83 Plus, TI-86, or TI-89 calculator. The cable has the small I/O plug on both ends. This cable is included with a CBL 2 or LabPro interface.
Vernier™ Vernier Resistor Board
The Vernier Resistor Board has seven 1 W 5% resistors mounted on a circuit board. Test clip holes on either side of the resistors allow for easy connections to clips on wire leads.
- 1
- 2