Mills

Grainger Sq. End Mill Single End Carb 0.0350

The Grainger Approved Square End Mill Single End is a high-speed steel end mill with a square end for milling slots, keyways, and pockets. It has a straight shank and is uncoated with an overall length of 2 inches and a shank diameter of 1/2 inch. The number of flutes is 2 and it has a right hand spiral. The end mill has an American Standard taper shank and a square end style. The primary application is slotting.

Fritsch Milling And Sizing Inc Support Walls P-1 Cl Size 2 Hardmetal Tungsten Carbide

Small and Specialty Supplier Partner
Small and/or specialty supplier based on Federal laws and SBA requirements.
Learn More

Lateral support walls made of hardmetal tungsten carbide for FRITSCH Jaw Crusher PULVERISETTE 1 classic line Size 2.

General material specification:
Material: hardmetal tungsten carbide - GC40 - WC
Abrasion resistance: very good
Suitable for: hard, abrasive samples

Grainger Ball End Mill Single End 1/4 C

Ball End Mill Single End 1/4 Carbide

Grainger Face Mill MFK 4000R1114T MFK 4

Face Mill MFK 4000R1114T MFK 400 Dia

Grainger Face Mill MFPN 45160R12T MFPN

Face Mill MFPN 45160R12T MFPN 160mm

Grainger END MILL 1/32 DIA 1/16 CUT CAR

502779250 END MILL 1/32 DIA 1/16 CUT CAR

Grainger BALL END MILL SINGLE END 1/2 C

502779224 BALL END MILL SINGLE END 1/2 C

Grainger BALL END MILL SINGLE END 3/16

502779389 BALL END MILL SINGLE END 3/16

Grainger SQ. END MILL SINGLE END CARB 3

502779333 SQ. END MILL SINGLE END CARB 3

Grainger Sq. End Mill Single End Carb 3

Sq. End Mill Single End Carb 3/8

Grainger Sq. End Mill Single End Carb 9

Sq. End Mill Single End Carb 9/16

Grainger Ball End Mill Single End 3/8 C

Ball End Mill Single End 3/8 Carbide

Grainger Face Mill MFK 5000R1118T MFK 5

Face Mill MFK 5000R1118T MFK 500 Dia

Grainger Sq. End Mill Single End Carb 9/32

The Grainger Approved Square End Mill Single End is a high-speed steel end mill with a square end for milling slots, keyways, and pockets. It has a 1/2" shank diameter, 1" overall length, and a 1/4" cutting diameter. The end mill has 4 flutes and a right-hand spiral. It is designed for use on steel, cast iron, aluminum, and other non-ferrous metals at speeds up to 2000 SFM. The end mill is made in the USA by Grainger Approved to tight tolerances for accurate cuts.

Grainger Face Mill MSR 063R2 MSR 63mm D

Face Mill MSR 063R2 MSR 63mm Diatin