Harnesses and Harness Accessories
Perkin Elmer US LLC Consumables Kit for NexION 5000 Configuration
PerkinElmer introduces the NexION 5000 ICP-MS Standard solution-ready sample introduction technology. It is engineered for the widest range of ICP-MS analyses. This kit includes: Fixed 2.0 mm Injector UHP Quartz Torch, Qty. 2 (N8152428) SilQ Cyclonic Spray Chamber with Matrix Gas Port, Qty. 1 (N8152539) Threaded Spray Chamber Drain Line, Qty. 2 (N8152456) Platinum Skimmer Cone for NexION 5000, Qty. 2 (N8161041) Platinum Sampler Cone, Qty. 2 (W1033614) Hyper Skimmer Cone for NexION 5000, Qty. 1 (N8160120) Sampler Cone Gasket, Qty. 3 (W1040148) Hyper Skimmer O-Ring, Qty. 2 (09902123) Gray/Gray Pump Tubing, Qty. 2 (N8152415) Flared PVC 0.51 mm Orange/Yellow Pump Tubing, Qty. 4 (N8152405) Drain Tubing (feet), Qty. 6 (02506495) Sample Uptake Tubing, Qty. 12 (WE024375) Sample Introduction Line for PFA-ST Nebulizer, Qty. 1 (N8152455) Female Barb CTFE Fitting, Qty. 4 (N8152388) Male Barb CTFE Fitting, Qty. 4 (N8152453) Instrument Filter (Left), Qty. 2 (N815216 Instrument Filter (Right), Qty.
Grainger Wiring Harness 15 ft.
The Grainger 16X432 is a 16-inch diameter, 432 RPM, 1/3 HP, 115V, single phase, open drip proof motor. It has a 56C frame with a 1.15 service factor and features a cast iron body with a thermally protected enclosure. This general purpose motor can be used for various industrial applications.
Grainger G2386 Arc Flash Body Harness ExoFit NEX L
The 3M DBI-SALA Full Body Harness Arc Flash is a full body harness designed for arc flash protection. It features a lightweight, breathable design with a quick-connect chest strap and leg straps for easy donning and doffing. The harness has an arc rating of 40 cal/cm2 and is made of flame resistant webbing that meets NFPA 70E standards. It comes in sizes ranging from small to 4XL. Key features include a back D-ring for fall arrest and positioning, a front D-ring for ladder climbing, and sub-pelvic strap for comfort when sitting. This harness provides arc flash protection for electrical and utility workers.
Grainger Wire Rope Stop Sleeve 1/8 in SS
The Loos Wire Rope Stop Sleeve Stop is a wire rope fitting designed to prevent fraying of wire rope ends. It is made from drop-forged steel and has a U-bolt design with serrated edges to grip the wire rope securely. This wire rope stop can be installed by sliding it over the end of the wire rope and tightening the U-bolt using a wrench. It is available in multiple sizes to accommodate wire rope diameters from 1/4" to 1-1/4". The working load limit ranges from 1,260 lbs to 23,760 lbs depending on the wire rope diameter. This wire rope end stop provides a finished look and helps protect against accidents caused by frayed wire rope ends.