Antistatic and ESD Mats
GA International Permanent Autoclave-Resistant Thermal-Transfer Labels 2" x 4" / 50.8mm x 101.6mm Rectangle Orange From -60°C to +150°C (-76°F to +302°F)
High temperature-resistant permanent labels for identifying various containers and surfaces that undergo autoclaving and dry heat sterilization. Temperature range from -60°C to +150°C (-76°F to +300°F). The labels can be applied to metal, plastic, and glass surfaces and withstand 20 autoclave sterilization cycles at +121°C (+250°F) and 16.5 psi pressure. The labels and the printout can withstand high temperature exposures as well as gamma irradiation (up to 50 KGy) and ethylene oxide sterilization. Ideal for identifying containers and surfaces that need to be sterilized inside autoclaves, dry-heat sterilizing equipment, and with gamma irradiators. Waterproof, weatherproof, thermal-transfer printable.The upper point temperature might slightly vary depending on the duration of the exposure.
ACL Inc MAT ANTI-STATIC ESD DUALMAT
ESD Workbench Products, Anti-Static Mats, Static Dissipative Mats, Staticide Dualmat, 36 in.x72 in. dark gray pre-cut mat, 2-layer rubber, 10^6-10^8 ohms per square, compliant to ANSI / ESDA S20.20
ACL Inc MAT ANTI-STATIC ESD DUALMAT
ESD Workbench Products, Anti-Static Mats, Static Dissipative Mats, Staticide Dualmat, 24 in.x36 in. light blue pre-cut mat, 2-layer rubber, 10^6-10^8 ohms per square, compliant to ANSI / ESDA S20.20
ACL Inc Table Mat ESD 24" X 48" Light Blue
ESD Workbench Products, Anti-Static Mats, Static Dissipative Mats, Staticide Dualmat, 24 in.x48 in. light blue pre-cut mat, 2-layer rubber, 10^6-10^8 ohms per square, compliant to ANSI / ESDA S20.20
ACL Inc MAT ANTI-STATIC ESD DUALMAT
ESD Workbench Products, Anti-Static Mats, Static Dissipative Mats, Staticide Dualmat, 24 in.x72 in. dark gray pre-cut mat, 2-layer rubber, 10^6-10^8 ohms per square, compliant to ANSI / ESDA S20.20
Electron Microscopy Sciences Heel Grounder with 1 Mega Ohm Resistor Blue
E.Z. Close is your low cost logical choice heel grounder. They are made from premium grade non-marking conductive rubber that is highly abrasion and wear resistant. The Velcro fastening system is adjust-able and comfortable. Includes: 18" conductive tab and 1 1/2", two-layer, rubber cup. Built in resistor. Charge decay: less than 0.01 sec.; 2.4x108 ohms . Meets DOD-263A standards (USA).