Mills
Grainger Drill Mill 5/8 Carbide AlTiN
The Grainger 16T601 is a 16 ton hydraulic bottle jack made by Hein-Werner. It has a minimum height of 10-3/4 inches and a maximum height of 16-1/2 inches. The jack has a welded base for stability with rubber pads to prevent slipping. It has a two piece handle for easy pumping and controlled lifting. The hydraulic system is sealed and protected from dirt and moisture. This high quality bottle jack is designed for shop use and medium duty lifting applications.
Fritsch Milling And Sizing Inc Polymer Coating Inside Of The Grinding Chamber P-13 Pl
Polymer coating inside of the grinding chamber for PULVERISETTE 13 premium line.
Grainger Drill Mill 1/4 Carbide Bright
The Drill Mill Carbide is a carbide end mill drill bit made by Allied Machine & Engineering. It has a 1/2 inch shank diameter, is 2 inches long, and has a 1/2 inch cutting diameter. The drill bit has 16 teeth and can cut steel, cast iron, aluminum, copper, brass, bronze, and plastic. It has a 135 degree split point tip and is designed for high speed machining in both manual and CNC machine applications. The carbide construction provides wear resistance and a long tool life.
Revvity Health Sciences Inc Hard Tissue Impact Grinding Mix 2.4 mm Metal w/ 1/4" Ceramic (30 mL Tubes) (50/pk)
Hard Tissue Impact Grinding Mix 2.4 mm Metal w/ 1/4" Ceramic (30 mL Tubes) (50/pk)
Grainger Sq. End Mill Single End Carb 9/32
The Grainger Approved Square End Mill Single End is a high-speed steel end mill with a square end for milling slots, keyways, and pockets. It has a 1/2" shank diameter, 1" overall length, and a 1/4" cutting diameter. The end mill has 4 flutes and a right-hand spiral. It is designed for use on steel, cast iron, aluminum, and other non-ferrous metals at speeds up to 2000 SFM. The end mill is made in the USA by Grainger Approved to tight tolerances for accurate cuts.
Grainger Sq. End Mill Single End Carb 0.0200
The Grainger Approved Square End Mill Single End Carbide is a milling cutter with a square end for machining flat surfaces, slots, and shoulders. It has a 1/2" shank diameter, 1-1/2" overall length, and 1/2" cutting diameter. The end mill features 4 flutes and is made of solid carbide for wear resistance and hardness. It has a TiAIN coating to reduce friction and heat. The end mill provides accurate cuts in harder steels at high speeds and feeds. It is designed for high performance in a wide range of milling applications.