Electron Microscope Accessories
Electron Microscopy Sciences Multi Pin Holder 45 degree for 3 pin stubs
This 25.4 mm in diameter 45 Degree multi pin holder is designed to save time. It allows for a higher SE signal without having to tilt the specimen It is made from machined aluminum with stainless steel Allen set screws. It accommodates up to three standard 12.7 mm (1/2") pin stubs with 3.2 mm (1/8") pin.
Electron Microscopy Sciences JEOL SEM Cylinder Mount 1-1/4" surface, 3/8" height, Aluminum
Cylinder specimen mounts are for use with JEOL scanning electron microscopes. The mounts are made from ultra-pure aluminum with a standard lathe finish.
Head: 1-1/4"
Height: 3/8"
Electron Microscopy Sciences SEM Cylinder Mount 45° Angle 1" Surface, Aluminum
Scanning electron microscope specimen mount with 45 degree angle. Made from lathe finished ultra-pure aluminum.
Head: 1"
Height: 13/16"
Electron Microscopy Sciences Thin Section Holder 3.2 mm (1⁄8") x 8mm
This mount holder which is made from machined aluminum with stainless steel Allen screws is specifically for 1" or 25 mm metallurgical mounts.
Electron Microscopy Sciences Forensic Certified SEM Mount 8 mm pin
This mount is made from a special certified Aluminum alloy which does not contain any of the objectionable elements that may interfere with samples collected for GSR . These mounts are 12.7 mm x 11 mm.
Electron Microscopy Sciences Multi Holder 45 degree for 6 pin stubs, Hitachi M4
This 35 mm in diameter 45 Degree multi pin holder is designed to save time. It allows for a higher SE signal without having to tilt the specimen. It is made from machined aluminum with stainless steel Allen set screws. It accommodates up to six standard 12.7 mm (1/2") pin stubs.
Type: Hitachi M4
Electron Microscopy Sciences JEOL SEM Cylinder Mount 1" surface, 13/16" height, Aluminum
Cylinder specimen mounts are for use with JEOL scanning electron microscopes. The mounts are made from ultra-pure aluminum with a standard lathe finish.
Head: 1"
Height: 13/16"
Electron Microscopy Sciences Multi Holder for 29 pin Stubs, Hitachi M4
This 90 mm in diameter multi pin holder is designed to save time. It is made from machined aluminum with 302 stainless steel springs that hold the pin stubs in place. It accommodates up to twenty nine standard 12.7 mm (1/2") pin stubs
Type: Hitachi M4
