Embedding Accessories
Adaptive Science Tools Microinjection Mold I-34
Six ramps used for micro-injection. Both sides are at a 90-degree angle firmly orienting the embryo.
Electron Microscopy Sciences Flat Embedding Mold Small Flat Embedding Mold, 4 mm deep, 10 x 6 mm
A clear silicone rubber with very high tear strength. It can be reused more times than the conventional silicone molds. It is resistant to most epoxy resins and its clear base allows positioning of the specimen lighted from beneath. This mold produces 12 embedding blocks with tapered ends.
Depth: 4 mm
Size: 10 x 6 mm
Cavities: 12
Electron Microscopy Sciences Embedding Ring, White
Molded from the highest quality plastic, our Embedding Rings fit most base molds. The large writing surface further eases identification and handling. The base measures 1 5/8" x 1 1/8" and the ring measures 1" x 1" (25 x 25 mm).
Ted Pella Inc DISPOSABLE BASE MOLDS
Disposable Base Molds, 37 x 24 x 10mm, Offer ease and convenience of operation, Excellent thermal exchange, Smooth interior finish
Electron Microscopy Sciences Lowicryl HM20 Monostep 225 GR
The same as our Lowicryl complete kits but this new formulation allows you one stop embedding without all of the cumbersome preparation and mixing. This pre-mixed, ready to use resin, saves you time and minimizes chemical contact. MonoStep Lowicryl is ideal for use in immunohistochemistry and immunolabeling. Store at room temperature.
Electron Microscopy Sciences EBH-2 Microtome Block Holder, 4 mm
Block holder molded from hard plastic. Easy to store block holders attached to Aluminum chucks (ABH). Frosted surface for easy marking. Large center hole prevents bubble formation.
Size: 4 mm
Electron Microscopy Sciences Slide Duplicating withCover Slip
The same design as above 70170 but with the addition of three round cavities which are 17 mm in diameter and 1 mm deep.
Electron Microscopy Sciences Easy-Molds™ for size 3 Capsules, 5.6 mm diameter
A newly designed mold which is convenient and offers better embedments. This tray-and-mold in one unit offers a unique specimen block that no other mold can. Each tray contains 2x10 block molds and measures 87x66 mm. Size: 5.6mm diameter corresponds to capsules size 3, and forms a block face of 1.6mm.
Electron Microscopy Sciences Easy-Molds™ for size 3 Capsules, 5.6 mm diameter
A newly designed mold which is convenient and offers better embedments. This tray-and-mold in one unit offers a unique specimen block that no other mold can. Each tray contains 2x10 block molds and measures 87x66 mm. Size: 5.6mm diameter corresponds to capsules size 3, and forms a block face of 1.6mm.